Renkforce WH2315 Bedienungsanleitung Seite 75

Setting function "REREGISTER TRANSMITTER"
You can register the outdoor sensor with the basis station again here.
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the " " (3) briefly repeatedly until the setting function "REREGISTER TRANSMITTER" is displayed.
Then briefly push the button "
Use the " " (1) or "
button.
All display areas of the outdoor sensor will now no longer display any data, but only dashes. The basis station will
now scan for the outdoor sensor.
When the basis station has found the signal of the outdoor sensor, measured values of the outdoor sensor will be
displayed on the basis station again.
If necessary, push the "RESET" (29) button on the bottom of the solar module to reset the outdoor sensor.
You may also need to remove the special rechargeable batteries from the outdoor sensor before starting
the setting function "REREGISTER TRANSMITTER" and cover the solar module for 1 minute. Insert the
special rechargeable batteries again after starting the setting function "REREGISTER TRANSMITTER".
If the outdoor sensor still cannot be found, proceed as described in chapter 9.
" (4).
" (2) to select the "ON" setting and leave the setting menu by briefly pushing the "HISTORY"
75