Safety Information; General Information; B) Operation - Renkforce WH2315 Bedienungsanleitung

6. Safety Information

Read the operating instructions attentively and particularly observe the safety notes. If the
safety notes and the information in these operating instructions regarding proper handling are
not observed, we assume no liability for any resulting injury/property damage. In such cases, the
warranty/guarantee will also lapse.
a) General Information
• T he unauthorised conversion and/or modification of the product is prohibited for safety and approval
reasons.
• The product is not a toy. Keep it away from children and pets.
• The manufacturer assumes no responsibility for incorrect displays, measured values or weather fore-
casts and their consequences.
• The product is intended for private use; it is not suitable for medical use or informing the public.
• Do not leave packaging material lying around carelessly. It may become a dangerous toy for children.
• When secure operation is no longer possible, shut off the product and protect it from inadvertent use.
Secure operation is no longer warranted if the product:
- has visible damage,
- no longer works properly,
- was stored under detrimental ambience conditions for an extended period or
- was subjected to considerable transport strain.
• Handle the product with care. Impact, blows or falls from even a low height will damage the product.
• Consult an expert if you are unsure as to the function, safety or connection of the product.
• Have maintenance, adjustment and repair work only performed by a specialist or specialist workshop.
• In case you have questions which are not answered in these operating instructions, contact our technical
service or other specialists.

b) Operation

• The basis station is intended for use in dry, closed indoor rooms only; it must not get damp or wet.
• The outdoor sensor is suitable to be used in an outdoor area. However, it must never be operated in or
under water; it would be destroyed by this!
• Never use the product immediately after it has been taken from a cold into a warm environment. The
condensation generated may destroy the product.
Let the basis station reach room temperature before taking it into operation again. This may take several
hours.
• Do not use the product inside of rooms or in bad ambient conditions where flammable gases, vapours or
explosive dust may be or are present! There is a danger of explosion!
53