Renkforce WH2315 Bedienungsanleitung Seite 62

Important!
The wind direction sensor has markings for the cardinal points ("N" = North).
Attach the metal tube with the sensors on it so that the "N" mark points due North. The correct directions
can be determined with a compass (e.g. integrated in some smartphones as an app or can be down-
loaded).
If you do not have a compass, you may also use a map or map material from the internet to perform at least
approximate alignment.
Observe the following for selection of the mounting site:
The mounting site must be exposed for wind speed and wind direction to be measured correctly. A mini-
mum distance to buildings of 10 metres is recommended.
Do not mount the outdoor sensor under or close to trees or bushes because dropping foliage may clog the
opening in the rain sensor.
For the solar module to best charge the rechargeable batteries, it should be in the sun all day if possible.
The range between the transmitter of the temperature/humidity sensor and the receiver in the basis station
is up to 150 m in a free range (at a direct line of sight between transmitter/receiver).
The range that can actually be achieved, however, is lower since there are walls, furniture, windows or
plants between the sensor and the basis station.
Another interference that strongly reduces range is proximity to electrical/electronic devices, cables or
metal parts. Reinforced concrete ceilings, metal-vaporised isolating glass windows or other devices on the
same transmission frequency (868 MHz) can also pose problems.
Before firmly attaching the metal tube with the outdoor sensors, you should perform a function and recep-
tion test. After inserting the rechargeable batteries into the outdoor sensor and batteries in the basis station,
the corresponding measured values should be displayed after several minutes.
62