D) Inserting Batteries/Rechargeable Batteries Into The Transmitter; E) Taking The Transmitter Into Operation; Inserting The Drive Battery In The Vehicle - Reely 1486282 Bedienungsanleitung

d) Inserting Batteries/Rechargeable Batteries into the Transmitter

Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Obser-
ve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.
Observe the enclosed operating instructions for the remote control system.

e) Taking the Transmitter into Operation

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.
If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.
f) Inserting the Drive battery in the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. d) and 9. e).
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH drive battery with 6 cells (nominal voltage 7.2 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed cont-
roller. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
Remove the bracket (A) of the battery holder by pulling out
the two safety clips (B) and then pulling out the bracket
upwards.
Now insert the drive battery so that the connection cable
of the rechargeable battery points backwards. Otherwise,
the connection cable could impair the steering mechanism
in its function.
Put on the bracket of the battery holder again and attach it
with the safety clips removed in the beginning.
39