Telecom Behnke 20-2940A-IP Anleitung Seite 32

IP camera 20-2940A-IP/21-2940A-IP, 20-2941A-IP/21-2941A-IP, 43-2940A, 50-2940A-IP
As factory default, LED illumination of the
camera is only turned on during a call.
Basic electronics IP
*
IP camera may only be operated with the cover on. Operation without the camera cover will damage the
camera. When opening the camera cover for servicing purposes, only loosen the two outer screws and
carefully lift off the camera cover. Heat sink in cover connected to camera.
www.behnke-online.de
Camera module, rear side
Input Output
LAN
Network cable (including PoE to camera)
LED illumination power supply cable
(Lighting not for 43-9582 / 43-9582A)
Turning on the LED illumination depends on
the operations mode set for relay 2 of your
SIP door intercom.
GB
Introduction
*
32