Telecom Behnke 20-2940A-IP Anleitung Seite 31

IP camera 20-2940A-IP/21-2940A-IP, 20-2941A-IP/21-2941A-IP, 43-2940A, 50-2940A-IP
GB
Introduction
LED illumination of the camera is permanently
on
Basic electronics IP
*
IP camera may only be operated with the cover on. Operation without the camera cover will damage the
camera. When opening the camera cover for servicing purposes, only loosen the two outer screws and
carefully lift off the camera cover. Heat sink in cover connected to camera.
31
Camera module, rear side
Input Output
LAN
Network cable (including PoE to camera)
Connection cable for power supply to the
LED illumination connected directly to the
SIP intercom station. Can also be connected
to a labelling unit (12 V). Labelling unit con-
nection see instructions for the SIP intercom
station
www.behnke-online.de
*