LauraStar LIFT Bedienungsanleitung Und Sicherheitshinweise Seite 6

A
B
3-6 mins
Start up
CAUTION: Always fill the water reservoir completely for best
performance.
NOTICE: Operating the appliance without water can damage the
appliance and will void any limited warranties provided with
your appliance.
Filling
• Lift the cover of the water reservoir and remove the reservoir by
pulling on the cover. Insert the filter cartridge (17) provided and fill
with tap water.
• Replace the reservoir (4) by lifting the cover, then close.
Switching on your appliance
• Plug in the iron.
• Press the On/Off switch (7); the white indicator light will flash for
3-6 minutes.
• When the white indicator light stops flashing, the appliance is ready.
NOTE: For your comfort and safety, your Laurastar steam station
will switch off after 10 minutes of not being used.
NOTE: Before ironing, or after an extended break, press the iron's
steam button 2 or 3 times, while pointing it away from the clothes.
This will release any condensation from the iron and prevent
water marks on the clothes.
WARNING: Do not point the iron at people or pets while
using vertical steam.
Ironing
A
Setting the temperature of the iron
(only available with certain models)
Set the thermostat (11) to • • or • • •.
NOTE: After changing the temperature setting, it takes
approximately 2 minutes before the new temperature is stabilised.
A
B
- 5 -
- 5 -
A