LauraStar LIFT Bedienungsanleitung Und Sicherheitshinweise Seite 11

Problems and solutions
Before calling the Laurastar Customer Service department, please check the following points :
Symptom
Makes a buzzing noise when steam is
emitted from the iron.
Makes a crackling noise when the
appliance is switched on.
The white indicator light flashes
during ironing.
The iron no longer emits steam. The
pressure has fallen.
The light remains red when the
reservoir is full.
Symptom
The soleplate drips.
The iron does not heat up.
Return to the Customer Service department
Switch off the appliance and disconnect the plug. Locate your purchase contract, invoice or receipt.
Telephone the Customer Service department and follow the instructions given.
Likely cause
Generator vibration (1).
The appliance has been set to heat up.
The water has been reheated.
The reservoir (4) is empty.
•
The appliance is switched off.
•
The plug (15) is disconnected.
•
The reservoir has not been correctly
replaced.
Likely cause
The iron is not ready.
•
The appliance has not been drained
•
recently.
The reservoir has been rinsed with a
•
product other than water.
The plug (15) is disconnected.
•
The On/Off switch (7) is off.
•
- 10 -
- 10 -
Remedy
This noise is normal for a new
appliance, it will disappear in the
course of use.
This noise is normal when the
appliance is heating up.
The appliance is working normally.
Fill the reservoir with water – page 4.
•
Press the appliance's On/Off switch (7).
•
Connect the plug.
•
Remove the reservoir and replace it
correctly in the base, with the cover
open.
Remedy
Wait until the white indicator light on
•
the On/Off switch (7) stops flashing.
Drain the appliance.
•
Call the Customer Service
•
department.
Connect the plug.
•
Switch on the appliance.
•
EN
EN