Multifuoco 2003 Ventilation Kit With Radio Control; Remote Control - Piazzetta MULTIFUOCO 2003 Einbau- Und Bedienungsanleitung

1. MULTIFUOCO 2003 VENTILATION KIT WITH RADIO CONTROL

The e900M, e903, e903M, e903k '97, e904, e904M, e904k '97 stoves are predisposed for the installation of the
"Multifuoco 2003 Ventilation kit with radio control". This system, patented by Gruppo Piazzetta S.p.A., makes it possible
to heat one or more rooms uniformly thus preventing layering of hot air near the ceiling.
Installation of the fan kit does not entail an increase in the heat output of the appliance, but rather the heating of
the room (or rooms) uniformly in so far that this system (that allows aspiration from above and exhaust from below)
creates a recycling of hot air which impedes ceiling stratification.
If the Kit is to be mounted after the stove has been installed, remember that the grid fastened to the front panel must be
removed to exhaust air in the front area for the e900M, e903M, e903k '97, e904M, and e904k '97 stoves (see heater
instructions).
The Fan kit is provided with a support onto which the fan is attached, the hot air exhaust outlets, the flexible hose, the
3
PT probe with fastening bracket, the remote control box, wiring, the fan (which has an airflow of approximately 220 m /
h, power capacity of 47 Watts) and the portable remote control with 4 buttons (fed by low-voltage batteries).
The e904c Fan kit is not furnished with the outlet and the flexible hose.
The remote control is equipped with an (ON/OFF) button which has two functions, i.e. "turning on / turning off", a button
for switching to automatic operation (AUTO) and two buttons (+/-) governing the fan operating speed (minimum speed
V1, average speed V2, maximum average speed V3, maximum speed, V4).
To identify the operating speed setting of the fan, simply listen to the number of beeps emitted when the + and -
buttons of the remote control are pressed (1 beep for each increase in speed), when manually shutting off the fan, a
long beep is heard which signifies that the system has been turned off.
The probe allows the fan to automatically start and stop when the temperature reaches the turn-on and turn-off
thresholds.

REMOTE CONTROL

37