VHF E5 Originalbetriebsanleitung Seite 93

Exchanging the working chamber door
F . 270 P
IG OSITIONING PIN ON THE
F . 271 P
IG OSITIONING PIN HOLE AT THE REAR OF THE
(
MODULE HIGHLIGHTED IN GREEN
F . 272
IG
13. Use the torque screwdriver (5.0 Nm with TX25 bit)
and tighten the A-B axis module crosswise with the
4 washers (highlighted in orange) and the 4 fixing
screws.
( )
MARKED ORANGE DRIVESHAFT
A-B
AXIS
)
Original Operating Instructions: E5
Version: 2/10/2023
14. Attach the 4 cover caps to the 4 fixing screws of the
A-B axis module.
F . 273
IG
F . 274
IG
F . 275
IG
15. Connect the A-B axis module power cable to the
connection on the lower left side of the A-B axis
module:
a. Plug in the cable.
b. Close the screw cap.
EN 93