VHF E5 Originalbetriebsanleitung Seite 4

EN 4
7.5 Guaranty
7.6 Maintenance table
7.6.1 Once per day
7.6.2 Once per week
7.6.3 Every 2 years
7.6.4 When necessary
7.7 Spare and wear parts
7.7.1 Definition of wear parts
7.7.2 Spare parts list
7.8 Cleaning the machine
7.8.1 Performing the daily cleaning
7.8.2 Performing the weekly cleaning
7.9 Clean or replace the collet cuck of the spindle
7.9.1 Removing the collet chuck
7.9.2 Cleaning the collet chuck
7.9.3 Inserting the collet chuck
7.10 Exchanging clamping devices and blank holders
7.10.1 Exchanging the clamping devices
7.10.2 Exchanging the blank holder
7.11 Exchanging tool magazine inserts and associated
holders
7.12 Exchanging the bellow
7.13 Exchanging the spindle unit
7.14 Exchanging the system module
7.15 Exchanging the system module locking bolt
7.16 Exchanging the measuring key protective cap
7.17 Exchanging the measuring key
7.18 Exchanging the fuser latches and clamping blocks on
the upper service cover
7.19 Exchanging the fuser latches and clamping blocks on
the lower service cover
7.20 Exchanging the gasket of the working chamber door 86
7.21 Replacing the A-B axis module cover caps
8.1 Exchanging the working chamber door
8.2 Replacing the A-B axis module
8.3 Exchanging the main fuse
8.4 Calibrating the axes
8.5 Updating the software and firmware
8.5.1 Updating DENTALCAM & DENTALCNC
8.5.2 Updating the firmware of the machine
9 Troubleshooting
9.1 Links to troubleshooting guides
9.2 Machine-specific notes
9.2.1 Loud machining noise
9.2.2 How to proceed in the event of a machine mal-
function
9.2.3 How to proceed in the event of a tool breakage
9.2.4 How to proceed in the event of a power failure
9.3 Emergency opening of the working chamber door
9.4 Removing broken tools from the collet chuck
10 Disposal
40
41
41
41
41
41
42
42
42
44
44
45
47
47
48
48
50
50
51
54
59
66
73
76
78
80
82
84
88
89
91
95
96
97
97
97
98
98
98
98
98
98
98
100
101
102
Original Operating Instructions: E5
Version: 2/10/2023
10.1 Disposing machining residues
10.1.1 General
10.1.2 Solid machining residues
10.2 Disposing of the machine
10.3 Dismantling, transport and packaging
Index
Table of contents
102
102
102
102
102
103