Performing The Weekly Cleaning - VHF E5 Originalbetriebsanleitung

Maintenance
9. Close the working chamber door.
10. Move the axes into the default position by
selecting the depicted icon in the Machin-
ing view in DENTALCNC.
11. Open the Maintenance Section with the following
icon in the main toolbar:
12. Select the icon shown for the Daily machine
cleaning entry.
F . 72
IG
7.8.2 Performing the w eekly cleaning
1. Carry out the daily maintenance.
2. Have ready:
1 x Cleaning cloth
n
F . 73
IG
1 x mild cleaner (optional)
n
F . 74
IG
1 x Microfiber cloth
n
3. Clean all surfaces and clearances in the working
4. Close the working chamber door.
5. If necessary, clean the viewing window with a
6. Move the axes into the default position by
7. Open the Machining parameters view with
8. Move the axes into the tool
9. Clean the housing:
Original Operating Instructions: E5
Version: 2/10/2023
chamber thoroughly with the dry cloth. Use a mild
cleaning agent if necessary.
cloth. Use a mild cleaning agent if necessary.
F . 75
IG
selecting the depicted icon in the Machin-
ing view in DENTALCNC.
the icon shown in the local toolbar.
change position by selecting
the depicted icon in the Machin-
ing view in DENTALCNC.
NOTICE! Housing damage caused by
incorrect aids and cleaning
a. Clean the surface with a dry microfiber cloth.
Be careful not to detach the symbol stickers.
The adhesive foil is especially sensitive to fric-
tion and harsh cleaning agents.
EN 45