Horizon Hobby E-FLITE Turbo Timber SWS 2.0m Bedienungsanleitung Seite 31

FCC Information
BRWSPMAR8360T
FCC ID:
This equipment complies with FCC and IC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator and/or antenna and your body
(excluding fingers, hands, wrists, ankles and feet). This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter
Supplier's Declaration of Conformity
EFL Turbo Timber 2.0m (EFL71750/ELF71765):
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
IC Information
IC: 6157A-SPMAR8360T
CAN ICES-3 (B)/NMB-3(B)
This device contains license-exempt transmitter(s)/receivers(s) that comply with
Innovation, Science, and Economic Development Canada's license-exempt RSS(s).
Operation is subject to the following 2 conditions:
Compliance Information for the European Union
EU Compliance Statement:
EFL Turbo TimberSWS Basic 2.0m (ELF71765):
Hereby, Horizon Hobby, LLC declares that the device is in compliance with
the following: EU Radio Equipment Directive 2014/53/EU, RoHS 2 Directive 2011/65/
EU, RoHS 3 Directive - Amending 2011/65/EU Annex II 2015/863.
The full text of the EU declaration of conformity is available at the following internet
address: https://www.horizonhobby.com/content/support-render-compliance.
EU Compliance Statement:
EFL Turbo Timber SWS PNP 2.0m (EFL71750):
Hereby, Horizon Hobby, LLC declares that the device is in compliance with
the following: EU Radio Equipment Directive 2014/53/EU, RoHS 2 Directive 2011/65/
EU, RoHS 3 Directive - Amending 2011/65/EU Annex II 2015/863.
The full text of the EU declaration of conformity is available at the following internet
address: https://www.horizonhobby.com/content/support-render-compliance.
Receiver:
2404-2476MHz
19.42dBm
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Horizon Hobby, LLC
2904 Research Rd.
Champaign, IL 61822
Email: compliance@horizonhobby.com
Web: HorizonHobby.com
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
EU Manufacturer of Record:
Horizon Hobby, LLC
2904 Research Road
Champaign, IL 61822 USA
EU Importer of Record:
Horizon Hobby, GmbH
Hanskampring 9
22885 Barsbüttel Germany
WEEE NOTICE:
This appliance is labeled in accordance with European Directive 2012/19/
EU concerning waste of electrical and electronic equipment (WEEE). This
label indicates that this product should not be disposed of with household
waste. It should be deposited at an appropriate facility to enable recovery
and recycling.
EN
31