Marzocchi Super Z Bedienungsanleitung Seite 8

AIR SPRING VOLUME SPACERS
Changing volume spacers in Marzocchi Super Z forks is an easy internal adjustment that
allows you to change the amount of mid stroke and bottom out resistance. If you have
set your sag correctly and are using full travel (bottoming out) too easily, then you could
install one or more spacers to increase bottom out resistance. If you are not using full
travel, then you could remove one or more spacers to decrease bottom out resistance.
1. Remove the air cap.
2. Release all air pressure from the fork by depressing the Schrader valve.
Marzocchi forks may contain high air pressures. Release ALL air pressure from the
main air chamber before disassembly. Failure to do so may result in parts or fluids
ejecting from the fork, which can cause SEVERE INJURY OR DEATH.
3. Carefully unthread the topcap from the fork with a 6-point chamfer-less 32 mm
socket.
4. Pull up to remove the topcap assembly from the fork crown.
5. Slide the air volume spacer or spacers horizontally to install or remove them from
the topcap.
Do not exceed the maximum number of volume spacers for your fork. This can
damage your fork. Find volume spacer information online at www.Marzocchi.com.
6. Reinstall the topcap assembly into the fork crown and tighten to 24.8 N•m (220 in-lb)
with a 6-point chamfer-less 32 mm socket.
7. Add air pressure to your desired setting using a high-pressure pump. Set the sag
according to instructions online at www.Marzocchi.com.
WARNING
WARNING
8