Connecting The Ip Camera; Lan Connection; Power Supply - Telecom Behnke 21-2906A-IP Anleitung

IP camera Instructions
GB
Introduction

1.5. Connecting the IP camera

LAN connection

Usually, an RJ-45 connector is used to establish
LAN connection ( page 22 + 23). When
*
operated with the series 20 IP basic electronics ,
the network connection can also be established
*
via the series 20 IP basic electronics . To do so,
connect the camera module's RJ-45 socket to the
socket marked "Port 2" of the Series 20 basic
*
electronics using a .patch cable.

Power supply

Power for the Behnke IP camera is supplied via
the ethernet port (PoE). When operated with
*
the series 20 IP basic electronics , power for
the camera is supplied via PoE from the IP basic
electronics.
Illumination
Cameras featuring illumination (20-2906A-IP
and 21-2906A-IP) are equipped with an addi-
tional cable ( page 22 + 23) to supply
power for the illumination unit. Continuous
power supply is possible. Alternatively, you may
use your SIP door intercom's relay 2 to supply
power for the illumination unit. You may choose
from any form of configuration to be realised via
the SIP door intercom's relay operations modes.
*
20-0001A-IP, 20-0002A-IP, 20-0013A-IP, 20-0014A-IP, 20-0016A-IP, 20-0041A-IP, 20-0043A-IP
www.behnke-online.com 21