Ossur REBOUND DUAL Gebrauchsanweisung Seite 7

Range of Motion (ROM) Adjustment
The device has 0° extension stops attached to the hinges. If needed, the
range of motion can be adjusted using the extension and flexion stop kits.
1. Lift and turn tab 90° (Fig. 9).
2. Remove existing stop if necessary, by pulling on the lower edge of the
installed stop (Fig. 10).
3. Insert desired flexion/extension stop with the number facing the
opposite direction of leg (Fig. 11).
4. Return tab to initial position and press downward to lock in place
(Fig. 12).
5. Follow the same procedure to change any additional stops and repeat
on the opposite hinge.
PCL Strap Attachment
The PCL kit is designed to counteract posterior subluxation of the tibia.
Trim and adjust the PCL strap for proper fit.
Attaching PCL Strap:
1. Note height position on medial and lateral Hinge Arms (H).
2. Remove hook-and-loop fastener to access connection area.
3. Remove Acculign Hinge Screws (J) and Acculign Hinge D-Ring.
4. Position PCL Acculign Hinge D-Ring and position PCL Acculign Hinge
Inserts with raised portion into the recessed pocket.
5. Return frame to initial positions on Hinge Arms.
6. Tighten Acculign Hinge Screws and re-apply hook-and-loop fastener.
7. Attach PCL strap.
Device Removal
1. Sit down and bend the knee at an 80° angle with the foot flat on the
floor.
2. Unfasten all posterior straps of the device and attach the straps back
to themselves. This will make it easier to put the device on next time
and will also prolong the life of the straps.
Accessories and Replacement Parts
Please refer to the Össur catalog for a list of available replacement parts
or accessories.
USAGE
Cleaning and care
Washing Instructions
Washing the device with the soft goods detached allows for more
thorough cleaning.
• Hand-wash using mild detergent and rinse thoroughly.
• Air dry.
Note: Do not machine-wash, tumble dry, iron, bleach, or wash with fabric
softener.
Note: Avoid contact with salt water or chlorinated water. In case of
contact, rinse with fresh water and air dry.
Hinge
• Remove foreign materials (e. g., dirt or grass) and clean using fresh
water.
• Do not disassemble the hinge.
7