Dismantling Housing; Disconnect The Tender From The Locomotive; Renew/Remove The Printed Circuit Board; Exchanging The Light Bulbs - BRAWA BR 19.1 Betriebsanleitung

Maintenance works on the tender
10. Dismantle housing (Fig. 6)
Unscrew the screws (190) and take out the housing (02) from the top.
11. Disconnect the tender from the locomotive (Fig. 6)
If the tender is to be disconnected from the locomotive, the printed cir­
cuit board (175) must be dismantled, see item 12. Unscrew the screw
(206) and disconnect the tnder from the locomotive.
12. Renew/remove printed circuit board (Fig. 6)
Dismantle the housing, see item 10. Unscrew the fixing screws (174)
and take out the printed circuit board (175) from the top. Remove all
cables by pulling off the cable support (166). Please mark where the
individual cables were fixed.
Attention: If the printed circuit board is dismantled to disconnect the
tender and locomotive, only the cables at the printed
circuit board which are connected to the tender have to
be removed.
13. Exchanging the light bulbs (Fig. 6)
Dismantle the housing, see item 10. Pulling off the cable/cable support
(166) of the damaged bulb (13) at the pcb (175).
14. Maintenance work on wheelsets (Fig. 6)
Unclips the according wheelset (194) from the bogie (195).
15. Replace the standard coupling shaft (Fig. 6)
Dismantle the housing, see item 10. Unscrew the fixing screws (174)
and remove the cover (208). Take off the standard coupling shaft (224)
and unclip the bow coupling (183).
16. Replace the premium digital decoder (Fig. 6)
Dismantle the housing, see item 10. Pull off the premium digital deco­
der (219) and plug in the new one.
17. Digital operation (Fig. 6)
Alternating current version
Locomotives of the alternative current version AC are supplied with a
premium digital decoder (219) as a standard. The decoder recognises
the type of operation (analog/digital) independently. If the decoder re
reprogrammed, refer to the installation and operating instructions for
the premium digital decoder.
The decoder is set to address 03 in the factory.
Direct current version
Dismantle the housing, see item 10. Pull off the dummy plug (176) and
plug in the digital decoder. Correct installation of the digital decoder,
its plugin direction and programming are given in the digital
decoder manufacturer's operating instructions.
12