Inhaltsverzeichnis
Werbung
Maintenance works
2. Dismantling housing (Fig. 4, Page15 )
Dismantle driver's cab (1):
Using a small screwdriver, unclip the 4 mounting clips by lifting
upwards. Remove the driver's cab upwards.
Dismantling the casing front / back (3):
Slightly squeeze casing to release the mounting clips. Remove
the casing upwards.
3. Exchanging the circuit board (Fig. 4,Page 15)
Remove casing, see item 2.
Unscrew the two mounting screws and remove weighted lid (6).
Slightly tip the circuit board (7) and unsolder the power supply
cable (8). Unsolder the cable from the motor (9) to the circuit
board.
Note:
Make a note of how the cables were soldered. otherwise
direction may be wrong.
4. Lighting
This locomotive is fitted with maintenance-free light-emitting
diodes. If a defect occurs in the light-emitting diodes, please
contact your specialist dealer or the manufacturer.
5. Exchanging the motor (Fig. 4, Page 15)
Remove housing and circuit board, see item 2 and 3.
Unsolder motor cables (9) from circuit board (7). Unscrew
mounting screws (8) front / back and remove weights
(13 / 14). Unclip bogie attachment (15) with a small screw
driver. Remove endless screw (16) and cardan shaft (17) from
their holders. Remove bogie (18) downwards. Pull tank (19) off
the underside (fastened with adhesive tape). Using a screwdriver,
push engine bearings (20) upwards from the bottom plate (21),
remove engine (22) with both motor bearing halves.
Caution: When removing the engine, please note the installation
position, otherwise direction may be wrong.
6. Maintenance work on the upper gear part
(Fig. 4, Page 15)
Dismantle casing, circuit board and bulbs, see item 2 to 4.
Unscrew mounting screws (12) front / back and remove weights.
Unclip the bogie attachment (15) with asmall screwdriver.
Remove endless screw (16) and cardan shaft (17) from holder.
1 2
Werbung
Inhaltsverzeichnis
