Werbung
Verfügbare Sprachen
Verfügbare Sprachen
U
No-load voltage rated value
0
Standardised operating
U
voltage
2
Plasma cutter PPS 40 B3
• Introduction
Congratulations! You have
purchased one of our high-quality products.
Please familiarise yourself with the product
before using it for the first time. Please also
read the safety instructions carefully. This
product must be set up or used only by
people who have been trained to do so.
Keep out of the reach of children!
NOTE!
fThe use of the term 'product' or 'device'
in the following text refers to the
plasma cutter named in these operating
instructions.
• Intended use
The device is intended for compressed-air
plasma cutting of all electrically conductive
metals. Observing the safety instructions
and assembly instructions and operating
information in the instructions for use is also
a component of the intended use.
It is imperative to adhere to the applicable
accident prevention regulations. The device
must not be used:
in insufficiently ventilated rooms,
„
Rated value of the mains
U
voltage
1
in moist or wet environments,
„
in explosive environments,
„
to defrost pipes,
„
in close proximity to people with cardiac
„
pacemakers and
in close proximity to easily flammable
„
materials.
Use the product only as described and only
for the specific applications as stated. Keep
these instructions in a safe place. Ensure you
hand over all documentation when passing
the product on to anyone else. Any use that
differs to the intended use as stated above
is prohibited and potentially dangerous.
Damage or injury caused by misuse or dis-
regarding the above warning is not covered
by the warranty or any liability on the part of
the manufacturer. The device is not intended
for commercial use. Commercial use will
void the guarantee.
RESIDUAL RISK
Even if you operate the device as intended,
there will be residual risks.
The following hazards may occur in conjunc-
tion with the construction and design of this
plasma cutter:
GB/IE/NI/CY/MT
7
Werbung
