UNITED OFFICE ULG 300 B1 Bedienungsanleitung Und Sicherheitshinweise Seite 9

Setting up
For the safe and trouble-free operation of the device, the set-up location must
fulfil the following requirements:
■ Place the appliance on a firm, flat and level surface.
■ Set up the appliance so that there is enough free space in front of the laminator
to allow the pouch to come completely out of the laminator.
■ Do not operate the device in a hot, wet or extremely damp environment or
near flammable materials.
■ The mains power socket must be easily accessible, so that the power cable
can be easily disconnected in the event of an emergency.
Handling and use
In this chapter you will receive important information on the handling and opera-
tion of the appliance.
Suitable laminating pouches
For hot lamination, you can use pouches with a width of up to 320 mm and a
maximum thickness of 125 μm. Please note that each laminating pouch may only
be used once.
NOTE
► For hot lamination, use only laminating pouches that are expressly intended
for hot lamination.
► For cold lamination, use only laminating pouches that are expressly
intended for cold lamination.
► Take note that the laminating pouches supplied with the laminator are
intended exclusively for hot lamination.
│ GB │ IE
■ 6
ULG 300 B1