UNITED OFFICE ULG 300 B1 Bedienungsanleitung Und Sicherheitshinweise Seite 15

CAUTION
Possible damage to the device.
► Do not use aggressive or abrasive cleaning agents, as these may corrode
the surface of the casing.
♦ Clean the housing of the appliance only with a lightly moistened cloth and
a mild detergent.
Cleaning the inside of the appliance:
During every lamination, contaminants collect on the rollers inside the laminator.
Over time, this adversely affects the performance of the laminator. Therefore, you
should clean the rollers inside the laminator after every use.
♦ Prepare the appliance as described in the section Preparing for hot
lamination, until the green indicator lamp "Ready"
pouch thickness switch
♦ Then insert a sheet of A3 paper folded in the middle (maximum thickness
1.0 mm), without a pouch and with the fold at the front, slowly into the slot
for manual pouch insertion
♦ Release the sheet as soon as you notice that it is being pulled in automatically.
The contaminants on the rollers inside the laminator now firmly attach them-
selves to the sheet of paper. The paper is ejected from the pouch slot
laminator.
♦ Repeat this cleaning process several times. Use a fresh sheet of paper each
time.
When you no longer see any contaminants on the paper, the rollers inside the
laminator are clean.
Storage
♦ Allow the appliance to cool down before putting it away.
♦ Store the appliance in a clean, dry place away from direct sunlight.
│ GB │ IE
■ 12
e
to 80 mic.
5
.
6
lights up. Set the
0
of the
ULG 300 B1