Troubleshooting; Error Correction - Parkside PWSA 20-Li D4 Originalbetriebsanleitung

Troubleshooting

Remove the battery from the device before carrying out any maintenance, adjust-
ment or cleaning work on the device. Danger of electric shock!
Problems
Device doesn't start
Grinding tool does
not move although
the engine is run-
ning
Engine is slower
and stops
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
Possible Cause
Battery (5) discharged
Battery (5) not inserted
On/off switch (3) may be de-
fective
Engine faulty
Grinding disc nut is loose
Workpiece, remaining workpie-
ces or remaining grinding tools
block drive
Device is overloaded through
workpiece
Grinding disc nut is loose
Grinding disc is defective

Error correction

Charge the battery (observe the
separate operating instructions
for the rechargeable battery and
charger)
Insert battery
(see 'Operation')
Repair by Customer Care
Tighten grinding disc nut (see
„Installing/changing disc")
Remove blockages
Reduce pressure on grinding tool
Workpiece unsuitable
Tighten grinding disc nut (see
„Installing/changing disc")
Change grinding disc
GB
45