JVC GR-C7 Bedienungsanleitung Seite 26

For continuous documentation of longer events, the GR-C7E can be used as an independent video camera in
combination with either a deck-type or portable video recorder.
®Connect the AV OUT connector of the GR-C7E to the AUDIO IN and VIDEO IN connectors of the video re-
corder using either of the provided dubbing cables, depending on the deck you are using.
| Dubbing cable with 21-pin
| connector (provided)
Note:
ein this configuration, it is possible to obtain a con-
tinuous recording and an edited-out recording of the
same event simultaneously, because the GR-C7E's
start/stop button only controls the tape inside itself
Operation
1. Press the MONITOR button. The
camera output signal is now avail-
able via the dubbing cable.
2. Put the connected recorder in
the Record mode. Recording
will start. Tape start/stop should
be controlled with the recorder's
buttons.
To AV OUT
connector
while another tape loaded in the connected recorder
continues running. To record on the GR-C7E's tape,
follow the same recording procedure as mentioned
before. press REC STBY and then the start/stop
button.
@Connect the AV OUT connector of the GR-C7E to the 10-pin camera connector of the second recorder using
the optional VC-V810U conversion cable.
Operation
1. Press the MONITOR button.
10-pin camera connector \
To AVOUT €&
connector
VC-V810U
Conversion cable (optional)
Note:
2. Put the connected recorder in
the Recording Standby (Record-
Pause) mode.
@The viewfinder's mode indica-
tion corresponds to the state of
the connected recorder.
3. Press the start/stop button of
the GR-C7E to start recording.
Precautions
@Power is not supplied to the GR-C7E from the
connected VCR. Independent power supply is re-
quired for both the GR-C7E and the VCR.
elf you stop recording by pressing the GR-C7E's
start/stop button, the connected VCR also stops in
the Pause mode. However, the pause command
signal is not delivered to the connected VCR in the
27
following cases and, therefore, the VCR will start
automatically:
(1) when the GR-C7E is switched off or its battery
becomes discharged.
(2) when the VC-V810U cable is disconnected.
Therefore, before replacing the battery or tape for
the GR-C7E, put the connected VCR either in the
STOP or REC LOCK mode.