Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General notes
Compliance with and implementation of all relevant directives and safety measures for the
respective field of application is the sole responsibility of the operator. All risks resulting from
improper use are borne solely by the operator.
The described product may only be operated by authorized and instructed personnel. Training
and qualification of the operating personnel as well as ensuring that the product is operated
with responsibility are the sole responsibility of the operator!
Transportation
During transportation, avoid strong vibrations and mechanical stresses that can cause damage
to the product. Keep the original packaging in a dry and protected place for later use.
Storage
Always store the device in its original packaging. To protect against damage and excessive
material aging, store the device in an environment that is as dry, temperature-stable and dust-
free as possible.
Acclimatization
After each transportation and after storage under critical climatic conditions (e.g. high
temperature difference between inside and outside), allow the product to acclimatize at room
temperature for a minimum of two hours to prevent possible damage from condensation before
putting it into operation in the place of use. If necessary, extend the acclimatization phase if
the temperature differences are very high.
Make all supply connections only after the product has been acclimatized!
Permissible ambient conditions
The device is designed for indoor use only. The device is NOT suitable for outdoor use! The
device is NOT suitable for use in potentially explosive areas!
When used in corrosive atmospheres, the service life of the device may be reduced depending
on the concentration, duration and frequency of exposure.
Safety
General safety instructions
Before commissioning and using the device, familiarize yourself with all the safety regulations
and occupational safety guidelines applicable at the place of use and observe them at all
times.
Only operate the device if it is in faultless technical condition. In particular, ensure that there
is no visible damage on the device itself and, where applicable, on connected devices or the
supply connections.
If there is missing or misleading information on the device or regarding occupational safety,
contact the responsible safety specialist or our technical service.
Only use the device in accordance with the regulations on intended use.
Electrical safety
Before connecting the device to the power supply, ensure that the voltage indicated on the
rating plate matches the specifications of the local power utility company.
Ensure that the power supply circuit provided is protected by means of a residual-current device
(RCD).
Always use the power supply cord provided with the device.
Prior to use, check that the device and the power supply cord are free of visible damage.
46
Werbung
