Rosenbauer RS 14 SUPER SILENT EFI Betriebsanleitung Seite 85

3) Measurement of the insulation resistance, generator OFF:
1. Disconnect insulation monitor in order to prevent damage by a high test voltage or
to prevent a faulty measurement.
a. Remove generator governor: Open the four srews and pull the governor
downwards. ATTENTION! Do not tension connected wires.
b. Disconnect or convert following 2 conductors:
Unplug potential equaliza-
tion conductor from the
controller housing:
Remove both potential
equalization conductors
from the circuit board:
RS 14 EFI & RS 14 SUPER SILENT EFI – Rosenbauer
Reconnect the two ends of
the potential equalization
conductors:
EN
85