Werbung
4
Installation Procedure
Operating Modes
If the connection between the IPCU and the pump is done by means of an HV
NOTE
Cable with Safety Interlock, the cable must be connected to the pump F/T and
the small banana connector on the cable controller side must be inserted in the
corresponding "HV Cable Interlock" plug on the unit rear panel in order to be
able to switch on the HV.
If the connection is done with a single pole HV Cable without the
Safety Interlock, ensure that the jumper provided on the unit rear
panel is inserted in the "HV Cable Interlock" plug.
SERIAL Operation
The SERIAL is set in order to operate by connecting the controller to an external
NOTE
PC that uses the "HYPER TERMINAL" program of Windows. To operate in serial
mode, connect the serial port to the controller "Serial" connector on the rear
panel, run the Windows "HYPER TERMINAL" program on the PC with the
following settings:
COM1
9600 baud
No parity
data bits
1 stop bit
This way of operation will allow to verify the functionality of the unit in the
"SERIAL" operating mode, give the commands and get all the operating data.
See the "Technical Information" paragraph for details.
72/94
Ion Pumps Control Unit (Battery Backup) User Manual / 87-900-117-01 (D)
Werbung
