Werbung
4
Installation Procedure
Use
WARNING!
The controller must be installed in a way that allows an easy interruption of
the line voltage (disconnection of the line plug or interruption on the rack
general line switch).
During operation, the following environmental conditions must be
respected:
To connect the controller to the pump use the specific cables
supplied.
See the appendix "Technical Information" for detailed information
about the above mentioned and the other connections.
Use
This paragraph describes the fundamental operating procedures.
Detailed information and operating procedures that involve optional
connections or options are supplied in the paragraph "USE" of the
appendix "Technical Information".
Make all vacuum manifold and electrical connections and refer to the
connected pump instruction manual prior to operating the controller.
WARNING!
To avoid injury to personnel and damage to the equipment, if the pump is
laying on a table make sure it is steady. Never operate the pump if the pump
inlet is not connected to the system or blanked off.
66/94
Ion Pumps Control Unit (Battery Backup) User Manual / 87-900-117-01 (D)
temperature: from +5 °C to +40 °C
relative humidity: 0 – 95 % (non-condensing)
Werbung
