Werbung
4
Installation Procedure
Usage
Tab. 2
REF.
SIGNAL
1
HV1 Connector
2
HV2 Connector
3
HV3 Connector
4
BATTERY Connector
5
LINE INPUT
6
FUSE
7
SERIAL Connector
8
REMOTE Connector
9
HV1 Cable Interlock
10
HV2 Cable Interlock
11
HV3 Cable Interlock
Usage
This paragraph gives a general information on the use of the
controller. For details refer to the "Technical Information"
paragraph. When the controller is plugged to the Power Line and the
Line Switch on the rear panel is ON (I), it is able to operate with its
full set of features:
70/94
Ion Pumps Control Unit (Battery Backup) User Manual / 87-900-117-01 (D)
DESCRIPTION
HV Connector for Cable to Ion Pump 1
HV Connector for Cable to Ion Pump 2
HV Connector for Cable to Ion Pump 3
3 pin connector for cable to the Battery
Module containing the Line Input cable plug and the Line Switch
Protection Fuse holder (2 fuses)
DB9 connector for the Serial cable
DB25 connector for the REMOTE I/O connections
3 independent HV channels
-5000 Vdc maximum output Voltage
40 W maximum output Power for each channel
>30 mA maximum output current (short circuit condition) for
each channel
LOCAL-REMOTE I/O/SERIAL operating mode
START/PROTECT operation
Werbung
