Husqvarna TS 300 E Bedienungsanweisung Seite 9

To assemble the product
1. Put the conveyor cart (A) onto the frame (B).
A
B
2. Make sure that the wheels of the conveyor cart
moves freely along the sides of the frame.
To install the cutting blade
WARNING:
from the power supply.
CAUTION:
counterclockwaise thread.
1. Loosen the cover knobs on the blade guard cover to
access the blade.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
1. Read the operators manual carefully and make sure
that you understand the instructions.
2282 - 002 - 07.02.2024
Disconnect the power plug
The locknut of the blade is
Operation
Read and understand the
2. Lock the blade and turn the lock nut clockwise to
remove it.
3. Assemble the blade (B) onto the blade shaft (A) and
attach the blade flange (C).
A
4. Lock the blade and turn the lock nut (D)
counterclockwise to tighten the blade.
5. Install the blade guard cover and tighten the cover
knobs.
2. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
3. Make sure that only approved persons are in the
work area.
4. Do daily maintenance. Refer to
schedule on page 13 .
5. Make sure that the product is assembled correctly
and is not damaged.
B
C
D
Maintenance
9