Husqvarna TS 300 E Bedienungsanweisung Seite 13

Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
Maintenance
Do a check of the safety devices
of the product. Refer to
devices on the product on page
7 .
Clean the product externally. Re-
To clean the product exter-
fer to
nally on page 13 .
Do a check of the blade guard.
To do a check of the
Refer to
blade guard on page 7 .
Do maintenance on the wheels
of the conveyor cart.Refer to
do maintenance on the wheels of
the conveyor cart on page 13 .
Clean the wheels. Refer to
do maintenance on the wheels of
the conveyor cart on page 13 .
Do the maintenance on the wa-
To do main-
ter pump. Refer to
tenance on the water pump on
page 13 .
Clean the water pump. Refer to
To clean the water pump on
page 13 .
To clean the product externally
CAUTION:
washer to clean the product.
• Clean the product externally after each operation.
• Remove grease and oil from the handle.
To do maintenance on the wheels of the
conveyor cart
1. Stop the product.
2. Disconnect the power cord.
3. Do a check of the wheels on the conveyor cart.
2282 - 002 - 07.02.2024
Maintenance
Before you do any
Safety
To
To
Do not use a high-pressure
Daily
X
X
X
X
X
X
4. Clean around the wheels of the conveyor cart.
5. Replace the wheels if they are damaged.
To do maintenance on the water pump
1. Let water run through the water system for a short
period in order to prevent hoses to get blocked by
slurry.
To clean the water pump
1. Stop the product. Refer to
page 12 .
2. Disconnect the power cord.
3. Disconnect the water pump from the product.
4. Remove the suction filter (A) from the water pump.
After usage
X
To stop the product on
13