Husqvarna TS 300 E Bedienungsanweisung Seite 8

Pinch protection function, conveyor cart
The Pinch protection function of the conveyor cart is
used to make sure that you do not pinch your hands
during operation.
To do a check of the pinch protection, conveyor cart
1. Turn the locking hook (A) 180 degrees to get the
pinch protection (B) out.
A
B
2. Make sure there is space between the pinch
protection and the frame.
Water pump
The water pump (A) of the water system is used to
decrease the quantity of dust and keep the blade cool.
CAUTION:
dry.
Introduction
WARNING:
safety chapter before you assemble the
product.
8
A
Do not run the water pump
Read and understand the
• The water pump may only be used together with the
products in this manual.
• The water pump must be used in accordance with
the directions in this manual.
To do a check of the water pump
1. Fill the frame with water. Refer to
with water on page 11 .
2. Push the ON button on the product to engage the
water pump.
Safety instructions for maintenance
• Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• Only do the maintenance given in this operator's
manual. Let an approved service agent do all other
servicing.
• Clean the product to remove dangerous material
before you do the maintenance.
• Do not use a high-pressure washer to clean the
product.
• Do not use water to clean the motor and electric
parts.
• Before you do the maintenance, push the OFF
button and disconnect the power plug.
• Replace damaged, worn or broken parts.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
• Let an approved service agent do servicing on the
product regularly.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Do the maintenance to make sure that the product
operates correctly. Refer to
13 .
Assembly
To fill the frame
Introduction on page
2282 - 002 - 07.02.2024