Husqvarna TS 300 E Bedienungsanweisung Seite 14

5. Remove the partition wall (B) and clean the surfaces.
6. Loosen the pump impeller (C).
7. Pull out the pump impeller and shaft (D).
8. Clean the parts and the housing.
9. Remove iron particles from the magnetic rotor shaft.
WARNING:
off and power cord disconneted before you
do troubleshooting.
Problem
The product does not start.
The water pump does not start.
The water pump stops to pump
water.
To do before transportation, storage
and disposal
1. Stop the product. Refer to
page 12 .
2. Disconnect the power cord.
14
Troubleshooting schedule
Make sure that the motor is
Solution
Make sure that the power supply is correctly plugged in.
Do a check of the power cord.
Make sure that the hose is connected and not damaged.
Make sure that there is voltage in water pump circuit and mains supply.
Make sure the hose to the water pump is connected.
Make sure the valve on the water pump is set to the correct position.
Make sure that the water pump is clean. Refer to
page 13 .
Take out the water pump from the water and put it back.
Transportation, storage and disposal
To stop the product on
10. Make sure that the pump impeller is clean and turns
freely.
C
D
B
A
To clean the water pump on
2282 - 002 - 07.02.2024