Husqvarna TS 300 E Bedienungsanweisung Seite 11

The water pump supplies the blade with water.
To fill the frame with water
Make sure that the water level always is above the water
pump.
1. Push the OFF button to stop the product.
2. Fill the frame with water.
3. Make sure that the water pump is below water.
4. Start the product to start the dust and cooling
To start the product on page 11 .
system. Refer to
To start the product
WARNING:
before you connect the product to a power
supply.
WARNING:
from rotating blade.
WARNING:
when the blade is installed and operates.
1. Push the ON button.
2282 - 002 - 07.02.2024
Push the OFF button
Keep your hands away
Do not move the product
2. Make sure that the water pump starts automatically
when the motor starts.
3. Wait some seconds for the water slots in the
conveyor cart to be filled with water before you start
to cut.
To operate the product
WARNING:
blade during operation.
WARNING:
product, carefully read and understand the
safety chapter.
1. Make sure that the work area is safe. Refer to
area safety on page 4 .
2. Fill the frame with water and make sure that the
water pump is installed. Refer to
with water on page 11 .
3. Set the cutting depth. Refer to
depth on page 10 .
4. Start the product. Refer to
page 11 .
5. Push the conveyor cart to the blade.
6. Stop the product. Refer to
page 12 .
To plunge cut
The cutting arm is spring loaded and can be adjusted up
and down.
1. Loosen the cutting depth lever (A).
A
2. Use the handle (B) to lift the blade.
3. Use the handle on the cutting arm to adjust the
cutting blade to plunge cut in the work piece.
Keep hands away from
Before you operate the
Work
To fill the frame
To set the cutting
To start the product on
To stop the product on
B
11