Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Make sure that correct blade for the operation is
used.
7. Make sure that the blade is installed correctly and is
not damaged. Refer to
page 9 .
8. Make sure that the cutting blade does not touch the
conveyor cart. The cutting blade can damage the
cutting slot.
9. Do a check of the safety devices on the product.
Safety devices on the product on page 7
Refer to
10. Put the product on the work area. Make sure that the
surface is flat. Make sure that the transportation of
the product to and in the work area is done safely
and correctly. Refer to
disposal on page 14 .
11. Fill the frame with water. Refer to
with water on page 11 .
12. Make sure that the power cord and extension cable
are in good condition and not damaged.
13. Connect the product to a power source. Refer to
Electrical safety on page 4 .
To set the cutting depth
WARNING:
is off and that the power supply is
disconected.
1. Loosen the cutting depth lever (A).
A
2. Move the handle (B) up or down to adjust the cutting
depth.
3. Tighten the cutting depth lever (A) to set the cutting
depth.
To adjust the work height of the product
1. Make sure that the product is in position on flat
ground.
2. Use shim plates to adjust the work height of the
product.
10
To install the cutting blade on
Transportation, storage and
To fill the frame
Make sure that the product
B
Cutting blades
WARNING:
for other materials than which it is made for.
WARNING:
for wet cutting. The diamond blade must be
applicable to the same speed or a higher
speed than the value given on the product
type plate. Only use diamond blades that
are in compliance with national or regional
standards, for example EN13236 or ANSI
B7.1.
The cutting blade manufacturer gives warnings and
recommendations for the operation and correct
maintenance of the cutting blade. Those warnings are
supplied with the cutting blade.
Diamond blades
WARNING:
very hot when used. A diamond blade that
is too hot gives bad performance, blade
damage and is a safety risk.
WARNING:
blades to cut plastic material. The hot
diamond blade can melt the plastic, which
can cause a kickback.
•
Diamond blades have a steel core with segments
that are made of industrial diamonds.
•
Diamond blades are used for masonry, reinforced
concrete and stone.
•
Make sure that the diamond blade rotates in the
direction of the arrows shown on the diamond blade.
•
Always use a sharp diamond blade.
•
Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause
the diamond segments to come loose.
Water supply
The water supply is used to decrease dust and to keep
the blade temperature down.
Do not use a cutting blade
Only use diamond blades
Diamond blades become
Do not use diamond
2282 - 002 - 07.02.2024
Werbung
