Husqvarna TS 300 E Bedienungsanweisung Seite 12

To stop the product
1. Push the OFF button to stop the product.
2. Make sure that the cutting blade fully stops.
3. Disconnect the product from the power supply.
To set the blade to 45° angle
WARNING:
disconnect the power plug to stop the
product.
WARNING:
does not rotate.
The product can be set to 45° or 90° cutting operation.
Make sure to use gloves when you adjust the blade
angle.
1. Loosen the lock handle (A) of angle cutting.
A
12
Push the OFF button and
Make sure that the blade
B
2. Rotate the blade housing (B).
3. Tighten the lock handle to set 45° angle.
To set the depth stop
CAUTION:
blade is not rotating. Adjust the depth stop
when you change the cutting blade. Do a
check of the depth stop regularly or there
is a risk that the cutting slot and the water
system will not operate correctly.
Set the depth stop so the cutting blade gets maximum
depth without cutting into the conveyor cart.
1. Push down the cutting arm until the cutting blade hits
the bottom of the slot in the conveyor cart.
2. Hold down the cutting arm in this position.
3. Turn the depth stop screw to adjust the cutting depth
stop.
4. Tighten the locking nut.
5. Do a check of the position of the cutting blade by
moving the conveyor cart to its forward and rear end
position. Make sure that the cutting blade does not
hit the conveyor cart.
This must be done while the
2282 - 002 - 07.02.2024