Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11.6 How to remove and install:
Door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
Step 1
Fully open the door.
Step 2
Lift and press the clamping levers
(A) on the two door hinges.
Step 3
Close the oven door to the first opening position (approximately 70° angle). Hold the door at both
sides and pull it away from the oven at an upwards angle. Put the door with the outer side down on
a soft cloth on a stable surface.
Step 4
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
Step 5
Pull the door trim to the front to re‐
move it.
Step 6
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
Step 7
Clean the glass panel with water
and soap. Dry the glass panel care‐
fully. Do not clean the glass panels
in the dishwasher.
Step 8
After cleaning, do the above steps
in the opposite sequence.
Step 9
Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of the door
may overheat.
11.7 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
A
2
B
A
1
ENGLISH
59
Werbung
