Storage - Silvercrest IAN 108312 Bedienungsanleitung

NOTE
If...
–
–
–
GB
–
... the shaving heads/the cutting unit 2 must be replaced.
You can order the cutting unit 2, incl. shaving heads from
our customer service (see order card).
To replace the cutting unit 2 proceed as follows:
1) Press the release button 4 so that the cutting unit 2
pops open.
2) Overstretch the cutting unit 2 a little so it can be pulled
upwards and off .
3) Fit the new cutting unit 2 onto the shaver. Ensure that it
snaps into place and is seated fi rmly.

Storage

CAUTION! MATERIAL DAMAGE!
Never store the shaver in the case r while the appliance is
charging. Risk of overheating!
Always replace the protective cap 1 onto the cutting unit 2 when
■
you are not using the appliance. Ensure that the corner with the
long plastic sleeve lies above the release button 4. Otherwise,
the protective cap 1 cannot be fi tted.
60
... the shaving result is noticeably poorer, ...
... you have to the shave the same spot repeatedly
to achieve a good result, ...
... the shave takes much longer than usual, ...
... there is visible damage to the shaving heads, ...
SRR 3.7 B2