Storage - Silvercrest SRR 3.7 B2 Bedienungsanleitung

NOTE
If...
... the shaving result is noticeably poorer, ...
–
... you have to the shave the same spot repeatedly
–
to achieve a good result, ...
... the shave takes much longer than usual, ...
–
... there is visible damage to the shaving heads, ...
–
... the shaving heads/the cutting unit
You can order the cutting unit
our customer service (see section "Ordering spare parts").
To replace the cutting unit
1) Press the release button
pops open.
2) Overstretch the cutting unit
upwards and off.
3) Fit the new cutting unit
snaps into place and is seated firmly.

Storage

CAUTION! MATERIAL DAMAGE!
Never store the shaver in the case
charging. Risk of overheating!
■ Always replace the protective cap
you are not using the appliance. Ensure that the corner with the
long plastic sleeve lies above the release button
the protective cap
■ 16 │ GB │ IE │ NI
All manuals and user guides at all-guides.com
, incl. shaving heads from
proceed as follows:
so that the cutting unit
onto the shaver. Ensure that it
cannot be fitted.
must be replaced.
a little so it can be pulled
while the appliance is
onto the cutting unit
. Otherwise,
when
SRR 3.7 B2