Cordless Shaving - Silvercrest IAN 108312 Bedienungsanleitung

Cordless shaving

CAUTION! MATERIAL DAMAGE!
► This appliance is not suitable for wet shaving!
This shaver can be used without the power cable. In this case, you
must charge the appliance before fi rst use (see section "Charging
GB
the battery").
1) Ensure the cutting unit 2 is attached and locked in place.
2) Remove the protective cap 1.
3) Press the switch lock 7 and push the on/off switch 6 towards
the cutting unit 2. The green power light 8 lights up and the
shaver starts.
NOTE
► The best results are achieved if used on dry skin.
► It can take 2 to 3 weeks until the skin is accustomed to the
dry shaving system.
4) Move the shaving heads with straight and circular motions over
the skin.
5) After you covered all the areas you want to shave, set the on/off
switch 6 back into its initial position. The appliance stops and
the green power light 8 switches off .
6) Clean the shaver after every use with the supplied brush e.
For a more thorough cleaning, read the section "Cleaning and
care".
54 SRR 3.7 B2