Swim & Fun 1401 Bedienungsanleitung Seite 150

UK
Usage parameters d0 to d11
Code Condition
d0 IPM temperature
d1 Water temperature (inlet)
d2 Water temperature (outlet)
d3 Ambient temperature
d4 Frequency limitation code
d5 Pipe temperature
d6 Exhaust gas temperature
d7 Step of EEV
d8 Compressor working frequency
d9 Compressor current
d10 Fan Speed
d11 Error code for the last time
Remark: d4 Frequency limitation code, 0: No frequency limit; 1: Coil pipe temperature limit; 2: Overheating or overcooling
frequency limit; 4: Drive Current frequency limit; 8: Drive voltage frequency limit; 16:Drive high temperature frequency limit
Parameter setting
Select the parameter setting menu A and press the settings button B to enter the menu. Press C or
D button to choose values between P0 and P17 and press the setting button B to set the value.
Note
Press the settings button for 15 seconds to set P14 and P17
Usage of parameters P0 to P17
Code Name
P0 Mandatory defrosting
P3 Water pump
P7 Water temp. calibration
150
Scope
0-120 °C
-9 °C ~ 99 °C
-9 °C ~ 99 °C
-30 °C ~ 70°C
0, 1, 2, 4, 8, 16
-30 °C ~ 70 °C
0 °C ~ C5 °C (125 °C)
0~99
0~99Hz
0~30A
0-1200 (rpm)
All error codes
A B C D
De-
Area of application
fault
0-1 0
0-1 0
-9~9 0
MV-1401-1402-1403-1404-01-2024 . © All rights reserved Swim & Fun ApS
Remark
Real testing value
Real testing value
Real testing value
Flash if Real test value
<-9
Real testing value
Flash if Real test value
<-9
Real testing value
N*5
Real testing value
Real testing value
Real testing value
Remark
0: Default normal operation
1: mandatory defrosting
1: Always running;
0: Depends on the operation of the
compressor
Default setting: 0