Troubleshooting; Warranty - Cross Tools CPG 6000 DEV Original-Gebrauchsanweisung

Translation of the Original Operating Instructions

9. Troubleshooting

Engine does not start:
Enough fuel in the tank?
Yes
Ignition key switch set to "ON"?
Yes
Enough engine oil filled in?
Yes
Fuel flow to the filter?
Yes
If the device still does not function take it
to an authorized workshop
No electrical power at the connections:
Main switch set to "ON"?
Yes
Pole fuse set to "ON"?
Yes

10. Warranty

The present device was manufactured and inspected according to the latest methods. The seller warrants for
faultless material and workmanship in accordance with the legal regulations of the country in which the device
was purchased. The warranty period begins with the day of the purchase and is subject to the provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or manufacturing will
be eliminated free of charge. Any complaints are to be reported immediately upon their detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third parties.
Damage resulting from improper handling or operation, incorrect setting-up or storage, inappropriate connection
or installation or Acts of God or other external influences are excluded from warranty.
Parts being subject to wear and tear are excluded from warranty.
All parts were manufactured using maximum care and high-quality materials and are designed for a long lifecycle.
It should be understood, however, that the wear and tear depends on the kind of use, the intensity of use and the
internals of maintenance. Complying with the installation and maintenance information contained in the present
operating instructions will therefore considerably contribute to a long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the entire de-
vice. Replaced parts will pass into our property.
No
No
No
Observe low oil safe-
guard
No
No
No
13
Fill up the petrol tank
Set the ignition key switch to „ON
Top up with the recommended engine oil
Replace the filter
Set the main switch to „ON
Set the pole fuse to „ON
• Take the device to an authorised
workshop for repair.
• Replace the device.
29