Oil Change - Cross Tools CPG 6000 DEV Original-Gebrauchsanweisung

Translation of the Original Operating Instructions
6.2.

Oil change

Empty the oil as long as the engine is still warm in order to guarantee
a quick and complete drainage.
1. Remove the oil drain screw (fig. 14, no. 18) and the oil cap (fig.
14, no. 15) and drain the oil. Retighten the screw (fig. 14, no. 18)
including a new seal.
2. Fill the engine oil with the recommended quality
(see fig. 6.1) and check the oil level.
Oil fill capacity: 1.65 l (slight deviation possible)
Caution: Prolonged or repeated skin contact with used oil can cause skin cancer.Although the
risk is very low unless you come in contact with used oil on a daily basis, you should wash
your hands with soap and water as soon as possible after coming in
Note:Dispose of the waste oil in an environmentally responsible way. We recommend handing over the waste oil
in a closed container to a local disposal company for recycling.You can find this under, e.g. http://www.wer-
entsorgt-was.de/entsorger_suche.html Do not dispose of the waste oil in the trash or by pouring it out.
6.3. Maintenance of air filter
A dirty air filter limits air flow into the engine. Maintain the air filter regularly to prevent the generator from malfunc-
tioning. If you use the generator is very dusty areas, you must clean the air filter more often. Carry out a visual in-
spection for dirt and damages before every use.
Warning! Never use petrol or solvent with low flash point for cleaning the air filter. It can result
in fires or explosions.Follow the instructions and safety information on the packaging of the
solvent
1. Loosen the four screws from the cover, which is attached to the side of
the generator.Once you remove the cover, you can see the air filter
housing.
2. Loosen and remove the air filter cover. You can then remove the air fil-
ter from the housing.
3. Wash the air filter in non-flammable solvent and dry it carefully. The
solvent should be especially suitable for air filter cleaning.
4. Reinsert the air filter and the air filter cover and screw it on using fas-
tening screws.
5. Now you can attach the housing cover back on the generator using the
four screws.
Caution:Never operate the generator without the air filter.Doing so
can cause major engine damage and quick wearing of the engine.
6.4. Fuel filter maintenance
Recommended maintenance interval:
In order to be able to guarantee smooth operation of the engine, the fuel filter must be replaced. The specified
maintenance interval of the filter and other components is given in section 6.1.
The filter should be checked daily and replaced every 6 months or 100 hours. The filter should be replaced as de-
scribed in "Maintenance of filter". For this process, petrol- or diesel-resistant gloves and packaging for disposal
should be used. Dispose of the fuel in an environmentally responsible way.
14
15
16
17
11
c
ontact with waste oil.
27