Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem
The product works
with intermittent
operation.
The product
makes much
vibration and loud
noise.
The trimming result
is bad.
˜ Cleaning and maintenance
WARNING! Risk of injury!
m
Always switch the product off,
remove the battery
the product cool down before
performing inspection, maintenance
or cleaning works.
m
WARNING!
Risk of injury from moving dangerous
u
parts!
20 GB/IE/NI
Possible cause
Internal loose contact.
o
The on/off switch
o
defective.
The trimming assembly is dirty.
o
The motor is defective.
o
The line spool
[
]
o
enough cutting line.
Both or one of the cutting lines
o
are not protruding out of the
spool cap
.
[
]
The trimming assembly is dirty.
o
The battery
is not fully
[
]
o
charged.
and let
[
]
Action
Have the product repaired by
o
the Service Centre.
is
2 ]
[
Clean the trimming assembly
o
(see "Cleaning and
maintenance").
Have the product repaired by
o
the Service Centre.
Extend the cutting line if required
does not have
o
(see "Extending the cutting
line").
Replace the line spool
o
(see "Cleaning and
maintenance").
1. Remove the spool cap
2. Feed the cutting line through the
openings to the outside.
3. Reinstall the spool cap
Clean the trimming assembly
o
(see "Cleaning and
maintenance").
Charge the battery
o
(see "Charging the battery").
m
CAUTION!
Any maintenance and repair other than
u
described in this manual: Contact an
authorised service centre or a similarly
qualified person to check or repair the
product. Only use original parts.
NOTE
The following cleaning and servicing
u
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
m
WARNING! Risk of electric shock!
Do not spray the product with water and
u
do not immerse it in water.
[
]
.
[
]
.
[
]
[
]
Werbung
