Kärcher KM 130/300 R LPG Kurz- Betriebsanleitung Seite 10

Operating and Functional
Elements
Ignition lock
1 Ignition key
Position 0: Switch off engine
–
Position 1: Ignition on
–
Position 2: Start the engine
–
Function keys
2 Beacon lamp on/off
3 Horn
5 Blinker switch
Multi-functional display
1 Operating hour counter
2 Charge warning lamp
3 Oil pressure warning lamp
4 Cooling water temperature warning
lamp
5 Motor suction air
6 Warning lamp fuel reserve
- blinks for reserve
- illuminates when gas bottle is empty
7 Indicator lamp (not connected)
8 Indicator lamp (not connected)
9 Indicator parking light (option)
10 Indicator light low beam (option)
11 Indicator light blinker (option)
12 Indicator lamp - forward driving direc-
tion
13 Indicator lamp - reverse driving direc-
tion
14 Tank indicator (not connected)
10
Pedals
A Brake pedal
B Drive pedal
C Parking brake
Start up
General notes
 Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
Install/replace gas bottle
Warning
Only use replacement cylinders with 11 kg
contents of tested models.
Danger
Risk of injury!
Follow safety regulations for LPG vehi-
–
cles.
Formation of crusts and yellow-frothing
–
deposits on the gas cylinder indicate
leakiness.
Cylinders must be changed only by in-
–
structed persons.
Cylinders containing propellant gases
–
must not be changed in garages and
underground areas.
Do not smoke and use uncovered light
–
while changing the cylinder.
While changing cylinders, first close the
–
locking valve of the LPG cylinder firmly
and immediately put the protective cap
on the empty cylinder.
 Loosen the screw on the safety bar and
swivel the bar upwards.
 Insert the gas bottle all the way into the
opening.
 Important instruction: the screw con-
nection of the shutoff valve must point
straight down (vertical).
 Close the bracket closure.
3
-
EN
 Connect the gas tube with Union nut (2)
(use 30 mm spanner).
 Remove protective lid (1) from the con-
nection valve of the cylinder.
Note
Connection has a left threading.
Warning
Open the gas drawing valve (3) only after
starting the appliance (refer chapter Start-
ing the appliance).
Operation
Programme selection
1 Transport drive
2 Sweeping with sweep roller
3 Sweeping using roller brush and side
brushes
Lock/ release parking brake
 Loosen parking brake; press brake
pedal at the same time.
 Activate the parking brake; press brake
pedal at the same time.
Adjust engine speed
 You can use the accelerator to regulate
the engine speed.