Simons Voss Technologies PegaSys Door Handle 4.1 Kurzanleitung Seite 41

PegaSys Door Handle 4.1 Scandinavian Oval
Sealing escutcheon holes
Any escutcheon holes that exist may be used to ma-
nipulate the lock.
1. Seal any escutcheon holes with a blind cylinder, for
example.
2. In the case of FH versions, you must be install a
brass dummy cylinder or locking cylinder.
4. Scope of delivery
PegaSys DoorHandle 4.1 (Scandinavian Oval)

Special tool

Quick guide

Depending on version:
Adapter set, 7 mm spindle

Adapter sleeve, 8.5 mm spindle

Adapter sleeve, 10 mm spindle

Blank cylinder

5. Design
1
2
6. For door thickness X: prepare
threaded rods and spindle
ü Saw at hand.
ü Vernier calliper at hand.
ü PH2 screwdriver at hand.
1. For X: measure the door thickness.
3
2. For X: fasten the screws, threaded sleeves and
threaded rods together.
4
3. For X: mark the sawing points on the threaded rods
and spindle.
5
6
7
4. For X: use a suitable saw to cut the threaded rods
and spindle.
8
EN
7. For inner door handle, clock-
wise: prepare stud bolts
TX3 screwdriver at hand.
ü
1. Check whether you need to turn the inner handle
clockwise.
9
If yes, refit the PegaSys DoorHandle 4.1's stud
9
nuts as described.
2. Unscrew the PegaSys DoorHandle 4.1 rear (TX8).
10
3. Unscrew the stud nuts.
11
4. Re-fasten the stud nuts firmly in the new positions.
12
5. Screw the PegaSys DoorHandle 4.1 rear firmly into
place again (TX8, torque 1.1 Nm).
13
9 Stud nuts are fastened through the PegaSys
DoorHandle 4.1 rear again.
8. Programming the fitting
14
15
16
9. Installing the fitting
Door pre-drilled.
ü
PH2 screwdriver at hand.
ü
TX15 screwdriver at hand.
ü
ü Vernier calliper at hand.
ü Pincers at hand.
1. For S, M and L: measure the door thickness.
17
2. For S, M and L: determine the separation points on
the cut-to-length screws L1 and L2.
18
19
3. For S, M and L: trim the cut-to-length screws L1 and
L2.
20
4. Scope of delivery
41 / 60