Werbung
Verfügbare Sprachen
Verfügbare Sprachen
■
Remain alert at all times! Always pay atten-
tion to what you are doing and act with
common sense. Do not use the appliance if
you are distracted or feeling unwell.
WARNING!
Always wear safety goggles.
WARNING!
Always wear a dust mask!
Before use
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should
be checked regularly. The optimum charge
level is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦
Connect the battery pack
charger
(see fig. A).
♦
Insert the power plug into the socket. The
control LED
lights up red.
♦
The green LED
indicates that the charging
process is complete and the battery pack
ready.
ATTENTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
PWSA 20-Li F4
from or connect
to the high-speed
is
flashes, this means
has overheated and
both
is
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦
Allow the battery pack
handle.
Removing the battery pack
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Adjusting the blade guard
WARNING! RISK OF INJURY!
►
Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
RISK OF INJURY!
►
Always use the angle grinder with the blade
guard
. The blade guard should be
installed securely. Set it so that the highest
possible degree of safety is achieved, i.e.
the smallest possible part of the grinding
disc is exposed to the operator. The blade
guard
is designed to protect the operator
from fragments and accidental contact with
the grinding tool.
►
Make sure that the blade guard
at at least the same angle as the additional
handle
(see fig. B). Otherwise, you could
injure yourself on the roughing disc or cutting
disc.
to click into the
and remove the
to
as follows:
is fitted
GB │ CY
│
11
■
Werbung
