Medion MD 24089a Bedienungsanleitung Seite 95

Select the desired setting with the
Appliance control
Satellite A, B, C or D
Set motor position
Mobile reception
Appliance control
You can set the settings for controlling the satellite area from the satellite
receiver here.
DiSEqCeasy enables the aerial to be aligned to one of four satellites using the
connected DiSEqC switch.
Tone Burst is an alternative control method for switching special relays
("Tone Burst relay").
Sat A/B controls up to two satellites via the 22 kHz signal.
Device control is switched off in the "off" setting. Programme switching
accelerates this in systems with only one satellite.
Satellite A, B, C or D
A, B, C and D are the four positions for the DiSEqC swith.
Set motor position
The motor control of the satellite aerial can save the position settings for several
satellites. Here you can set a memory space for the aerial control for the desired
satellite.
Proceed as follows to assign a memory space:
Select the "Motor position" menu option and press the "OK" key. The
satellite list is displayed.
Select the desired satellites with the
Then select the desired memory space using the
modify the settings for the satellite aerial.
To open the motor control, press the "
menu is opened. The available commands are displayed in the left side of the
screen.
Use the "Position" option to select the satellites whose position you want to
set via the motor. The current reception quality is shown on the right side of
the screen.
MD 24089a
or key and press the "
DiSEqC easy,
DiSEqC easymotor,
Tone Burst,
Sat A/B 22 kHz,
Pff
Set satellite
Satellite list
Off, on
or
" key again. The motor control
OK
OK
key.
or key. You can now
" key.
UK
37