Help In Case Of Problems; Reception Problems For Some Channels - Medion MD 24089a Bedienungsanleitung

Help in case of problems

Symptom
No message in the display The power cable is not connected.
No sound or image, the
time indicator is lit on the
screen.
No sound or image,
poor image
Nor or only a weak signal. Check the cable connecting the LNB to the receiver and the
The TV does not display
any images.
The remote control does
not work.
Device does not respond. A false source key has been pressed. Press the "STB" source
For all other difficulties please refer to our service centre.

Reception problems for some channels

When using a wireless DECT telephone there may be reception problems in
individual cases for the channels Sat1, ProSieben, KABEL1, NEUN LIVE
Television, TELE5, DSF, N24 or Home Shopping Europe. These telephones
transmit in a frequency range on which the signals of the stated channels are
transmitted in common LNBs from the aerial to the receiver. If this is the case,
do the following:
Check the assembly and connection of the aerials.
If necessary get the aerial, its connections and cabling checked by a
specialist.
Set the base station for the DECT telephone as far as possible from the
receiver and aerial cables.
54
Possible cause/solutions
Connect the power cable to the mains socket.
The receiver is in standby mode.
Press the "STANDBY
and the channel is displayed on the TV screen.
The aerial is not aligned to the satellite.
Re-align the aerial. Observe the instructions in the aerial's
user manual.
The LNB is defective. Replace the LNB.
receiver to the connected appliances.
The system is not connected properly.
Check the connection to the SCART or HF cable.
The TV is not in AV mode.
Switch the TV to the appropriate AV input.
The batteries are dead.
Replace the batteries.
The remote control is pointing in the wrong direction.
Direct the remote control to the front of the receiver and
ensure that nothing is between the remote control and
receiver.
key for your satellite receiver.
" key. The receiver switches itself on