Manual Code Search - Medion MD 24089a Bedienungsanleitung

Enter the device code according to the code list
The codes of the corresponding devices can be found in the Code List enclosed
with these operating instructions. Proceed as follows:
1. Switch the relevant device on manually.
2. Briefly press the required source key (
3. Keep the
CODE
remains permanently lit.
4. Enter the four-digit code from the Code Table.
The blue LED will extinguish briefly each time the key is pressed.
If the entered code was valid, the blue LED will extinguish after the last
digit has been entered. If an invalid code was entered, the blue LED
flashes for approx. two seconds before extinguishing.
If the device does not respond as expected, repeat the programming, or try a
different code. Please try out all codes stated for your brand. Select the code for
which all the available -commands work on your remote control.
If this is not successful either, then try using the search method described in the
chapter "Automatic Search".

Manual code search

Carry out a manual search as follows:
1. Switch the relevant device on manually.
2. Briefly press the required source key (
3. Keep the
CODE
remains permanently lit.
4. Keep pressing the (up to 350 times)
the device that is to be controlled switches off, changes channels, or
responds accordingly. The code search begins at the currently stored
number.
5. Briefly press
OK
Due to the considerable quantity of different code numbers, up to 350
different codes are pre-programmed per device type. In individual cases
it may be possible that only the most common main functions are
available. The process described here may not work for some special
models.
48
key pressed for approx. 3 seconds until the blue LED
key pressed for approx. 3 seconds until the blue LED
to save the code.
TV, DVD, VCR, AUX
TV, DVD, VCR, AUX
, or
POWER P+ P–
).
).
or (VCR only) until