Automatic Search; Performing An Automatic Search - Medion MSH 3002 Handbuch

Automatic search

The automatic search function of the receiver searches for new TV and radio channels.
Coded/Scrambled TV channels are sorted out and not displayed. TV channels, which
already exist in the list, will be removed automatically.

Performing an automatic search

1. Open up the search function in "Channel List" / "Channel Search" which is available
through the main menu.
2. Choose from the list the satellite, which you wish to search "DVB-T" to search terres-
trial channels and confirm with OK.
3. Wait until the end of the search. The information shown is technical details regarding
the searched channels. The field "Totals" gives information about the channels found.
4. When the search is completed the select channels window will be displayed.
Select channels window
This window contains the channel list on the left and the list of newly found channels on
the right. To change between TV and radio channels use the TV and RADIO buttons on the
remote control. To change between the lists use the SWAP button. There are certain op-
tions available, to make use of these options choose a channel which you wish to change
from one of the lists and press OK, then choose an option from the menu which appears.
In operations where channel entries are to be added to the channel list, the selection is
moved to the left hand window and you are then required to select the target position with
the OK button.
Note: If the channel list is empty before the scan is performed the results will automatically
be copied into the left hand list.
52 MSH 3002